IP Configuration
IPv4 Management and Interfaces
308
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
16
To define an excluded address range:
STEP 1
Click
IP Configuration
>
IPv4 Management and Interfaces
>
DHCP Server
>
Excluded
Addresses
.
The previously-defined excluded IP addresses are displayed.
STEP 2
To add a range of IP addresses to be excluded, click
Add
, and enter the fields:
•
Start IP Address
—First IP address in the range of excluded IP addresses.
•
End IP Address
—Last IP address in the range of excluded IP addresses.
STEP 3
Click
Apply
. The Running Configuration file is updated.
Static Hosts
You might want to assign some DHCP clients a permanent IP address that never changes. This
client is then known as a static host.
You can define up to 120 static hosts.
To manually allocate a permanent IP address to a specific client:
STEP 1
Click
IP Configuration
>
IPv4 Management and Interfaces
>
DHCP Server
>
Static
Hosts
.
The static hosts are displayed. The fields displayed are described in the Add page, except for
the following:
•
MAC Address/Client Identifier—
.
STEP 2
To add a static host, click
Add
, and enter the fields:
•
IP Address—
Enter the IP address that was statically assigned to the host.
•
Host Name—
Enter the host name, which can be a string of symbols and an integer.
•
Mask—
Enter the static host’s network mask.
-
Network Mask
—Check and enter the static host’s network mask.
-
Prefix Length
—Check and enter the number of bits that comprise the address prefix.
•
Identifier Type—
Set how to identify the specific static host.
