2-45
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
OL-30864-01
Chapter 2 Installing the Access Point
Powering the Access Point
Figure 2-27
Inserting RJ-45 Connector into the Ethernet Port Opening in Case
Step 8
Slide the cable gland with the rubber seal towards the access point, and screw the threaded end of the
body into the access point, and hand-tighten.
Step 9
Use an adjustable wrench or a 28-mm wrench to tighten the threaded end of the body into the enclosure.
Tighten to 15 lb-in.
Step 10
Use an adjustable wrench and tighten the thread-lock seal nut to 15 lb-in.
Step 11
Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 12
Route your Ethernet cable, and cut off any excess cable.
Step 13
Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector. For typical
installation components, see
Step 14
Turn on power to the power injector.
Connecting a DC Power Cable to the Access Point
When powering the access point with DC power, you must ensure that DC power can be conveniently
removed from the unit. The power should not be removed by disconnecting the DC power connector on
the unit.
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement 1022
1
Ethernet port opening in access point case.
2
RJ-45 connector, on shielded outdoor-rated
Ethernet (CAT5e or better) cable
3
Exploded view of the cable gland,on the Ethernet cable.
352056
1
2
3
