2-20
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
OL-30864-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Step 6
Using the long bolt and the hardware supplied with the pivoting bracket, bolt the AP and its mounted
bracket, on to the bracket mounted on the wall (see
for an exploded view of this assembly).
Step 7
Pivot the AP to your desired position, and then tighten the bolts (using a 13 mm wrench).
Step 8
Continue with
Grounding the Access Point, page 2-40
Pole Mounting the Access Point with the Pivoting Mounting Kit
The optional pivoting mounting kit contains a mounting bracket for wall mounting or pole mounting,
along with a clamp for pole mounting.This kit can be used to install the access point on a pole, mast or
streetlight. It supports metal, wood or fiberglass poles from 2 to 8 inches in diameter.
Figure 2-10
Pivoting Mounting Kit with Pole Mount Clamp
1
Mounting holes for the access point
2
Slots for band clamps (band clamps are
provided but not shown in this figure. See
).
3
Pole mount clamp. It can fit poles of range up
to 3 in. (76mm)
1
2
3