2-4
Installation
4038501 Rev C
Mounting the Amplifier
To Mount the Amplifier
The amplifier should be
mounted vertically
with the cable input underneath, to secure
the best possible operating temperature conditions. Use a 5 mm Allen wrench to
tighten the screws on the lid from 6.5 to 7 Nm (58 in-lb to 62 in-lb).
The following illustration shows the arrows that indicate the mounting bolt positions.
CAUTION!
Be aware of the size and weight of the amplifier when mounting. Ensure that
the mounting location has a stable flat surface, and can safely support the
amplifier’s maximum weight. Use the appropriate type of screws and
screwdrivers, depending on the mounting method.
To Open and Tighten the Housing
Use a 5 mm Allen wrench to tighten or loosen the closure bolts. To ensure a proper
seal, tighten or loosen the bolts in sequence 1, 2, 3, and 4 as shown in the following
diagram.
The pin length of the PG 11 cable connector at input and output is shown on the
cover plate of the amplifier. If needed, trim the connector with a wire cutter.
