Chapter 9 Troubleshooting and Maintenance
Resolving Startup Problems
9-6
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
OL-14626-01
Cisco Unified Communications Manager group. If none of these options contain
IP addresses or show Active or Standby, the phone is not properly registered with
Cisco Unified Communications Manager. See the
“Registering the Phone with
Cisco Unified Communications Manager” section on page 9-8
for tips on
resolving this problem.
Cisco Unified Communications Manager and TFTP Services Are Not Running
If the Cisco Unified Communications Manager or TFTP services are not running,
phones may not be able to start up properly. However, in such a situation, it is
likely that you are experiencing a system-wide failure, and that other phones and
devices are unable to start up properly.
If the Cisco Unified Communications Manager service is not running, all devices
on the network that rely on it to make phone calls will be affected. If the TFTP
service is not running, many devices will not be able to start up successfully.
To start a service, follow these steps:
Procedure
Step 1
From Cisco Unified Communications Manager Administration, choose
Cisco
Unified Serviceability
from the Navigation drop-down list.
Step 2
Choose
Tools > Control Center - Network Services
.
Step 3
Choose the primary Cisco Unified Communications Manager server from the
Server drop-down list.
The window displays the service names for the server that you chose, the status
of the services, and a service control panel to stop or start a service.
Step 4
If a service has stopped, click its radio button and then click the
Start
button.
The Service Status symbol changes from a square to an arrow.
Note
A service must be activated before it can be started or stopped. To activate a
service, choose
Tools > Service Activation
.
Summary of Contents for 7970G - IP Phone VoIP
Page 4: ......
