Description
Item
DHCP, TFTP, CDP data.
Network Services Level
Application level security data.
Security Level
Key strokes, softkeys, MMI data.
User Interface Level
Channel scanning, authentication data.
Wireless Level
RTP, SRTP, RTCP, DSP data.
Audio Level
Firmware, upgrade data.
System Level
Wavelink Settings Fields
You can configure Wavelink settings from the phone CU. The following table describes the Wavelink settings.
Table 33: Wavelink settings
Description
Setting
Enables the Wavelink server.
Enable
Enables the use of alternate Wavelink server.
Use Alternate Server
If the User Alternate Server is enabled, enter an IP address for the alternate
server.
Alternate Server
Assign up to four attribute names to the phone to be used as selection
criteria.
Custom Name 1-4
Define the values for each Custom Name to be used as selection criteria.
Custom Value 1-4
Update Phone
When you have completed the phone configuration changes, you must export the configuration file from the
phone CU to Wavelink, and then update the phone.
The CU does not perform a complete validation of the phone configuration. If the configuration file
contains an invalid setting, the phone may reject the configuration and send an error message to the syslog.
Note
To update the phone with the updated configuration file, perform the following steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
144
Wavelink Avalanche Server
Wavelink Settings Fields
