Cisco IP Phone Cleaning
To clean your Cisco IP Phone, use only a dry soft cloth to gently wipe the phone and the phone screen. Do
not apply liquids or powders directly to the phone. As with all non-weatherproof electronics, liquids and
powders can damage the components and cause failures.
When the phone is in sleep mode, the screen is blank and the Select button is not lit. When the phone is in
this condition, you can clean the screen, as long as you know that the phone will remain asleep until after you
finish cleaning.
View Phone Information
Procedure
To check the current status of the Cisco IP Phone, click the
Info
tab.
The Info tab shows information about all phone extensions, including phone statistics and the registration
status.
Reboot Reasons
The phone stores the most recent five reasons that the phone was refreshed or rebooted. When the phone is
reset to factory defaults, this information is deleted.
The following table describes the reboot and refresh reasons for the Cisco IP Phone.
Description
Reason
The reboot was a result of an upgrade operation
(regardless whether the upgrade completed or failed).
Upgrade
The reboot was the result of changes made to
parameter values by using the IP phone screen or
phone web user interface, or as a result of
synchronization.
Provisioning
The reboot was triggered by a SIP request.
SIP Triggered
The reboot was triggered as a result of remote
customization.
RC
The user manually triggered a cold reboot.
User Triggered
The reboot was triggered after the phone IP address
changed.
IP Changed
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
325
Cisco IP Phone Troubleshooting
Cisco IP Phone Cleaning
