
3-43
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
OL-5052-14
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
1-Port OC-192c/STM-64 POS/RPR XFP SPA Interface Specifications
The framer processes incoming and outgoing SONET or SDH frames. The framer operates at
OC-192c/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA interface is compliant with the following RFCs:
•
RFC 1662,
PPP in HDLC-like Framing
•
RFC 2615,
PPP over SONET/SDH
For information on SNMP MIB support, see “Implementing SNMP on Cisco IOS XR Software” in
Cisco IOS XR System Management Configuration Guide
.
1-Port OC-192c/STM-64 POS/RPR XFP SPA Optical Transceiver Modules,
Connectors, and Cables
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA uses a single-mode, 9.95 Gbps, OC-192c optical fiber
(SONET STS-192c or SDH STM-64) optical transceiver module for SONET and SDH connection to the
network.
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA supports the following types of optical transceiver
module:
•
Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
•
Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
•
Single-mode very-long reach XFP module—XFP-10GZR-OC192LR
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of, the above-listed XFPs
are the only optical transceiver modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
ACTIVE
Off
Off
Port is not enabled by software.
Green
On
Port is enabled by software, and loopback is off.
Amber
On
Port is enabled by software, and loopback is on.
STATUS
Off
Off
SPA power off.
Green
On
SPA is ready and operational.
Amber
On
SPA power is on and good, and the SPA is being configured.
Table 3-20
1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs (continued)
LED Label
Color
State
Meaning