3-55
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
OL-5052-14
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
2-Port Gigabit Ethernet SPA Overview
2-Port Gigabit Ethernet SPA LEDs
The 2-Port Gigabit Ethernet SPA has two types of LEDs. There is an A/L LED for each port and one
STATUS LED as shown in
Figure 3-47
.
Figure 3-47
2-Port Gigabit Ethernet SPA Faceplate
The 2-Port Gigabit Ethernet SPA LEDs are described in
Table 3-29
.
2-Port Gigabit Ethernet SPA Cables and Connectors
The interface connectors on the 2-Port Gigabit Ethernet SPA are two individual fiber optic receivers that
support SFP modules. Each port can send and receive traffic using the optical fiber connections.
SFP Module Connections
The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet optical slots on the 2-Port Gigabit Ethernet SPA, linking the port with a 1000BASE-X
fiber-optic network.
Note
The 2-Port Gigabit Ethernet SPA will only accept the SFP modules listed as supported in this document.
An SFP check is run every time an SFP module is inserted into the 2-Port Gigabit Ethernet SPA and only
SFP modules that pass this check will be usable by the 2-Port Gigabit Ethernet SPA.
1
A/L LED (for each interface)
2
STATUS LED (for entire SPA)
277959
ST
AT
US
SPA-2X1GE--V2
A/L
0
A/L
1
A/L
0
1
A/L
2
1
Table 3-29
2-Port Gigabit Ethernet SPA LEDs
LED Label
Color
State
Meaning
A/L
Off
Off
Port is not enabled.
Green
On
The port is enabled and the link is up.
Amber
On
The port is enabled and the link is down.
STATUS
Off
Off
SPA power is off.
Green
On
SPA is ready and operational.
Amber
On
SPA power is on and good, and SPA is being configured.