Cisco 6823, Administration Manual, Page: 21 / 194

New or Updated Sections Feature
New tasks:
• Add a Second Line to a Handset, on page 71
• Share a Line Between Handsets, on page 72
• Handset Won't Register (Automatic
Configuration), on page 164
• Handset Won't Register (Manual Configuration),
on page 165
• Base Station LED Flashes Red and Handset
Displays No SIP Reg Message, on page 166
General changes
Set Up the Cisco IP DECT 6800 Series (Workflow)
Use the following workflow to guide you through the setup of the 110 Single-Cell Base Station or 210
Multi-Cell Base Station in your system.
This workflow is a plan for a single-base system. If you need to add another 110 Single-Cell Base Station or
Cisco IP DECT 210 Multi-Cell Base Station, or additional 210 Multi-Cell Base Stations, the additional base
stations require additional knowledge.
Note
Installation can take two approaches:
• Automatic: In this scenario, the base station and handsets are preconfigured by the service provider.
• Manual: In this scenario, the base station and handsets must be configured with the administration web
pages. The service provider needs to provide information to enable the system to communicate with the
call control service.
After you complete this workflow, you can configure directories, security, and additional features. For more
information, see
Phone Administration, on page 41 .
Procedure
Purpose Command or Action
Prepare for system installation. Installation Requirements, on page 19
Step 1
Check that the base station and network can
communicate. If the system uses automatic Install the Base Station, on page 25 Step 2
configuration, the system automatically
downloads its configuration.
Temporarily place the base station in the
planned locations and ensure that the Perform a Site Survey, on page 144 Step 3
Cisco IP DECT 6800 Series Administration Guide
13
Cisco IP DECT 6800 Series
Set Up the Cisco IP DECT 6800 Series (Workflow)