Cisco 3750 - Catalyst EMI Switch, Hardware Installation Manual

Page: 57 / 230

2-9
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 2 Product Overview
Front Panel Description
Note
100BASE-TX and 1000BASE-T traffic requires Category 5 cable. 10BASE-T
traffic can use Category 3 or Category 4 cables.
When connecting the switch to workstations, servers, routers, and Cisco IP
Phones, be sure that the cable is a straight-through cable. When connecting the
switch to switches or hubs, use a crossover cable. When using a straight-through
or crossover cable for 1000BASE-T connections, be sure to use a twisted
four-pair, Category 5 cable for proper operation. Pinouts for the cables are
described in
Appendix B, “Connector and Cable Specifications.”
Note
You can use the mdix auto interface configuration command in the CLI to enable
the automatic medium-dependent interface crossover (Auto-MDIX) feature.
When the Auto-MDIX feature is enabled, the switch detects the required cable
type for copper Ethernet connections and configures the interfaces accordingly.
Therefore, you can use either a crossover or a straight-through cable for
connections to a copper 10/100, 10/100/1000, or 1000BASE-T SFP module port
on the switch, regardless of the type of device on the other end of the connection.
The Auto-MDIX feature is enabled by default on switches running Cisco IOS
Release 12.2(18)SE or later. For releases between Cisco IOS
Release 12.1(14)EA1 and 12.2(18)SE, the Auto-MDIX feature is disabled by
default. For configuration information for this feature, refer to the switch software
configuration guide or the switch command reference
.