B-107
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform wireless-controller
debug platform wireless-controller
Use the
debug platform wireless-controller
privileged EXEC command to enable debugging of the
internal wireless LAN controller on a Catalyst 3750G Integrated Wireless LAN Controller Switch. Use
the
no
form of this command to disable debugging.
debug platform wireless-controller
{
all
|
packets
|
session
|
sm
|
wcp
}
no debug platform wireless-controller
{
all
|
packets
|
session
|
sm
|
wcp
}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
undebug platform wireless-controller
command is the same as the
no debug platform
wireless-controller
command.
This command applies only to the Catalyst 3750G Wireless LAN Controller Switch.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the
session
switch-number
privileged
EXEC command. Then enter the
debug
command at the command-line prompt of the stack member. You
also can use the
remote command
stack-member-number
LINE
privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all
Display all wireless controller debug messages.
packets
Display Wireless LAN Control Protocol (WCP) packet debug messages.
session
Display wireless controller session debug messages.
sm
Display wireless controller state machine debug messages.
wcp
Display all WCP debug messages.
Release
Modification
12.2(25)FZ
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
show platform
wireless-controller
Displays information about the internal wireless controller.
