![Cisco 3110 Message Manual Download Page 40](http://html.mh-extra.com/html/cisco/3110/3110_message-manual_19545040.webp)
2-24
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
DTP Messages
Error Message
DOT1X_SWITCH-5-ERR_VLAN_PROMISC_PORT: Attempt to assign VLAN [dec] to
promiscuous 802.1x port [chars]
Explanation
An attempt was made to assign a VLAN to a promiscuous IEEE 802.1x port, which is
not allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action
Change the mode of the port so that it is no longer a promiscuous port, or
change the configuration so that no VLAN is assigned.
Error Message
DOT1X_SWITCH-5-ERR_VLAN_RESERVED: Attempt to assign reserved VLAN
[dec] to 802.1x port [chars]
Explanation
An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
specified is a reserved VLAN and cannot be assigned to this port. [dec] is the VLAN, and [chars] is
the port.
Recommended Action
Update the configuration to not use this VLAN.
Error Message
DOT1X_SWITCH-5-ERR_VLAN_ROUTED_PORT: Attempt to assign VLAN [dec] to
routed 802.1x port [chars]
Explanation
An attempt was made to assign a VLAN to a routed IEEE 802.1x port, which is not
allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action
Change the mode of the port so that it is no longer a routed port, or change the
configuration so that no VLAN is assigned.
Error Message
DOT1X_SWITCH-5-ERR_VLAN_RSPAN: Attempt to assign RSPAN VLAN [dec] to
802.1x port [chars]. 802.1x is incompatible with RSPAN
Explanation
An attempt was made to assign a remote SPAN VLAN to an IEEE 802.1x port. Remote
SPAN should not be enabled on a VLAN in which ports are configured with IEEE 802.1x enabled.
[dec] is the VLAN, and [chars] is the port.
Recommended Action
Either disable remote SPAN configuration on the VLAN, or disable
IEEE 802.1x on all the ports in this VLAN.
DTP Messages
This section contains the Dynamic Trunking Protocol (DTP) messages.
Error Message
DTP-4-MEM_UNAVAIL: Memory was not available to perform the trunk
negotiation action.
Explanation
The system cannot negotiate trunks because of a lack of memory.
Recommended Action
Reduce other system activity to ease memory demands.