4-19
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
Chapter 4 Configuring the Router
Performing the Initial Configuration on the Router
Examples
The following example shows how to configure virtual terminal lines with a password:
!
line vty 0 4
password anyname
login
!
What to Do Next
After you configure the vty lines, follow these steps:
•
(Optional) To encrypt the virtual terminal line password, see the “Configuring Passwords and
Privileges” chapter in
Cisco IOS Security Configuration Guide
. Also see the
tech note.
•
(Optional) To secure the VTY lines with an access list, see the “Part 3: Traffic Filtering and
Firewalls” chapter in
Cisco IOS Security Configuration Guide
.
Configuring the Auxiliary Line
This section describes how to enter line configuration mode for the auxiliary line. How you configure
the auxiliary line depends on your particular implementation of the auxiliary (AUX) port. See
Configuring a Modem on the AUX Port for EXEC Dialin Connectivity
SUMMARY STEPS
1.
enable
2.
configure
terminal
3.
line
aux 0
Note
See the tech notes and sample configurations to configure the line for your particular
implementation of the AUX port.
Step 7
show running-config
Example:
Router# show running-config
Displays the running configuration file.
•
Verify that you properly configured the virtual terminal
lines for remote access.
Step 8
From another network device, attempt to open a Telnet
session to the router.
Example:
Router# 172.16.74.3
Password:
Verifies that you can remotely access the router and that the
virtual terminal line password is correctly configured.
Command or Action
Purpose
