4-43
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Chapter 4 System Startup and Basic System Configuration
Recovering a Lost Password
Step 7
Enter the
enable
command and password (if prompted).
Milo>
enable
Password: <
password
>
Milo#
Step 8
Enter the
show startup-config
command to display the enabled password in the
configuration file.
Milo#
show startup-config
.
.
.
password bambam
Step 9
Enter the
configure terminal
command to enter global configuration mode:
Milo#
configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
Milo(config)#
Step 10
Enter the
config-register
0x
value
command to change the software configuration
register value back to its original value which you noted in Step 1.
Milo(config)#
config-register 0x
value
Milo(config)#
Step 11
Press
Ctrl-Z
to exit global configuration mode.
Milo(config)#
Ctrl-Z
Milo#
Step 12
Reboot the router and use the recovered password with the
enable
command to
gain access to the router.
Summary of Contents for 12010 series
Page 6: ......
