Removing and Replacing Switch Cards
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
7-66
To verify that a new switch card is operating properly, perform the following steps:
Step 1
Observe the LEDs on the faceplate of the CSC(s), as follows:
•
For a new CSC—Observe the two status LEDs for the CSC (refer to
Figure 7-20). If the bottom (ENABLED) LED is on (green), the new CSC is
operational. If the top (FAIL) LED is on (amber), the new CSC is faulty (see
Table 7-2). In this case, proceed to Step 3.
Table 7-2
Status LEDs for the CSC
•
For a new SFC—The first (primary) indication of SFC status is provided by
the status LEDs for the SFCs located at the bottom of the CSC faceplate (see
Figure 7-20).
If the bottom (ENABLED) LED is on (green), the installed SFCs are
operational (see Table 7-3). This ends the validation procedure, except for
returning the air filter assembly to its proper place (see Step 3).
If the top (FAIL) LED is on (amber), one or more of the installed SFCs is
faulty (see Table 7-3). In this case, proceed with Step 2.
Table 7-3
Status LEDs for the SFCs
Status LEDs
State
Description
Top LED (FAIL)
On (amber)
Indicates that the CSC is faulty
Bottom LED (ENABLED)
On (green)
Indicates that the CSC is operational
Status LEDs
State
Description
Top LED (FAIL)
On (amber)
Indicates that a fault has been detected in one or
more of the SFCs.
Bottom LED (ENABLED
On (green)
Indicates that the SFCs are installed and
operating normally.
Both LEDs
Off
Indicates that no SFCs are installed in the router.
Summary of Contents for 12008
Page 4: ......
Page 12: ...Cisco 12008 Gigabit Switch Router Installation and Configuration Guide xii ...
Page 102: ...Agency Approvals Cisco 12008 Gigabit Switch Router Installation and Configuration Guide 1 80 ...
Page 132: ...Using a Site Log Cisco 12008 Gigabit Switch Router Installation and Configuration Guide 2 30 ...