Cisco 12008, Installation And Configuration Manual, Page: 189 / 382

Observing System Startup and Performing a Basic Configuration 4-5
Starting the System and Observing Initial Conditions
Figure 4-1 RP Alphanumeric LEDs (Partial Faceplate View)
Table 4-1 Typical Contents of the RP Alphanumeric LEDs
LED Display Meaning Source
MROM
nnnn
The MBus microcode begins to execute; nnnn is the
microcode version number. For example, microcode
version 1.17 would display as 0117.
1
This display might
not be visible, since it occurs briefly.
1. The version of MBus microcode running on your system might be different.
MBus
controller
LMEM
TEST
Low memory on the RP is being tested. RP rommon
MEM
INIT
The size of main memory on the RP is being discovered. RP rommon
RP
RDY
The system is operational and ready to execute basic IOS
commands at the ROM monitor prompt (
rommon>
).
RP rommon
RP
UP
A valid Cisco IOS image is running. RP IOS
MSTR
RP
The RP is enabled and recognized as the system master.
A valid Cisco IOS image is running. RP IOS
H10780
PROCESSOR
Upper alphanumeric
LED display (four digits)
Lower alphanumeric
LED display (four digits)