VCC-F32U29CL
Rev.
900-513-31-01
©2007 CIS Corporation. All rights reserved.
18
7.1.4. (Rear Panel SW7: - )
NC
7.1.5. RGB / RAW Selection Switch
（
Rear panel SW8: RGB/RAW
）
RGB/RAW
RGB / RAW selection
OFF RAW
output
ON RGB
output
7.1.6. RAW
8 bit / 10bit Selection Switch
（
Rear Panel SW9:8Bit/10Bit
）
8bit/10bit RAW
8 bit / 10 bit output selection
OFF RAW
8 bit output
ON RAW
10 bit output
※
Valid only when RAW output (SW8:OFF) is set.
7.1.7. HD / VD Input / Output Selection Switch (Rear panel SW10: IN/OUT)
IN/OUT
HD/VD Input Output selection
OFF
HD, VD output
ON
HD, VD input (Ext. Sync. mode)
※
This is the selection of 6pin(HD), 7pin(VD) of the circular type 12pins connector on the rear panel.
7.1.8. WEN
（
Write Enable
）
Signal Output
WEN signal is output through 10 pin of circular connector when video signal is output in the trigger mode.
By setting the data of address 055, WEN signal format can be changed.
Data :
0
･ ･ ･
single pulse VD (9H pulse width) (default setting)
: 1
･ ･ ･
FVAL (Frame enable)
:
2
･ ･ ･
Exposure
:
3
･ ･ ･
not assigned
* By adjusting the phase, the necessary amount of illumination can be reduced, incoming light overexposure
time can be eliminated, and consequently, amount of smear can be reduced.
7.2. 12 Turn Rotary Potentiometer for Manual Gain Adjustment
Adjustment range : -1dB
～
max +12dB
(The performance guarantee range : 0 ～ +6dB. When Gain is set over +6dB, artifacts such as vertical
stripe, beat noise, and shading may become visible.)
