VCC-5CXP3R
Rev. 905-0052-00
©2016 CIS Corporation. All rights reserved.
19
8.10
Camera Timing Output
The signals below can be output from 6pin circular connecter on camera rear by LineSource settings.
Digital IO Control
LineSelector
Line1
LineMode
Output
LineSource
OFF
ExposureActive
FrameActive
LineActive
TriggerPacketActive
・
LineSource
ExposureActive
:
To indicate exposure period of image sensor by Hi Active.
FrameActive
:To indicate effective period of frame by Hi Active.
LineActive
:To indicate effective period of line by Hi Active.
TriggerPacketActive
:To output uplink trigger packet signal from frame grabber by decoding.
8.11
DeviceUserID Settings
DeviceControl
DeviceUserID
[User definition]
The user-defined device names can be set in camera by a string of 16 characters. User-defined device names shall be saved in
EEPROM in camera when execute “UserSetSave.” It will revert to the factory setting when execute “UserDefault.”
※
This is a total of 16byte of register region. Please input in English one byte characters.
8.12
White Balance
AnalogControl
BalanceWhiteControl
Off
OnePush
Manual
3 types of mode can be use at Balance White control.
1) OFF
To output without White balance control.
2) One Push White Balance
White Balance shall be adjusted in accordance with output image.
Please execute while the achromatic object is on the entire screen. We recommend you to execute is with
approx. 50% of signal level. Red value, Green value, and Blue value after executed can be read out from
BalanceWhiteOnePushGainRed and BalanceWhiteOnePushBlue.
Aegis Electronic Group, Inc.
