VCC-5CXP3R
Rev. 905-0052-00
©2016 CIS Corporation. All rights reserved.
9
7.3.1 Internal Sync Mode (Free Run Mode)
This is a mode to use triggers continuously made in the camera. No external trigger shall be used.
・
Please set TriggerSelectorAndActvation to AcquisitionMode.
Configuration
Frame rate
(fps)
8bit
10bit
CXP-1
21.3
16.3
CXP-2
42.6
34.8
CXP-3
42.6
42.6
CXP-5
85.1
69.5
CXP-6
85.1
85.1
7.3.2 External Trigger Sync Mode
This is a mode to input external trigger signals to capture images by any preferred timings.
Some delay shall be considered from when camera recognized the trigger edge to when actual exposure starts.
Please refer to the delay time as below.
Input
Delay Time
LinkTrigger0
Approx. 3.4us
Line0
Approx. 150us
・
Notes for trigger pulse input timing
A trigger pulse can be input during Readout. However, please do not input a trigger pulse while reading out signals for the prior
frame since it ends its exposure. (In other words, please avoid inputting a trigger pulse while reading out signals for the prior
frame and starts reading out signals for the next frame.)
Video output from the camera might not be executed when the trigger is input again at the prohibited timing, or right after
FVAL turns to “L” at the timing of the end of exposure. If the camera stops operating, or cannot output image data without
malfunctions, please execute “SensorReset” command after quitting trigger input to start the operation again.
※
If the camera does not start its operation, please execute the restoration of power.
Device Control
SensorReset
(Execute)
Trigger
Exposure
FVAL
(
≒
Readout)
Aegis Electronic Group, Inc.
