95-01-01
Page 44
All
EFFECTIVITY:
C I R R U S
C O M P O N E N T M A I N T E N A N C E M A N U A L - C A P S
M O D E L S R 2 0
Serials 1268 thru 1422 after SB2X-95-17,
Serials 1423 & subs w/o Perspective after SB2X-95-18, 2228 & subs:
Verify minimum gap
of 0.13 inch (3.30 mm) exists between outer diameter of pick-up collar ring and aft side of
BH 222.
WARNING:
Incorrect gap between outer diameter of pick-up collar and aft side of
BH 222 may result in deployment failure.
Do not measure at lanyard legs extending outward from pickup collar.
(ab) Feed remaining lanyard aft until slack is removed and the lanyard is coiled back into the
stowage pocket in the parachute assembly. Ensure ends of lanyard routed aft do not wrap
around forward portion of rocket assembly and lanyard coil in the stowage pocket is not
twisted.
WARNING:
Verify rocket lanyard is positioned around top outer diameter of pick-
up collar support, NOT over top of the rocket. Failure to comply will
absolutely FAIL rocket deployment!
Verify rocket lanyard is routed around back of rocket and aft parachute
harness, NOT around front. Failure to comply will absolutely FAIL
rocket deployment!
(ac) Verify rocket lanyard is positioned around top outer diameter of pick-up collar support.
(ad) Carefully feed spiral wrap cable into adjustable bushing pass-through hole until slack is
removed.
(ae) Reposition CAPS harness.
(af)
Remove catch cloth from below rocket and parachute assembly.
(ag) Using a vacuum cleaner, remove all debris from fuselage floor.
(ah) Visually inspect parachute compartment for security, leaks, loose or missing hardware,
moisture, and general condition.
(ai)
Install access panel CB7 to BH 222. (Refer to AMM 6-00)
(aj)
Install BH 222 trim panel and carpet. (Refer to AMM 25-10)
(ak) Serials 1005 thru 1267 after SB2X-95-20,
Serials 1268 thru 1422 after SB2X-95-17,
1423 & subs w/o Perspective after SB2X-95-18, 2228 & subs:
Connect battery 1. (Refer to
AMM 24-30)
(7)
Inspection/Check - Rocket Motor Case Alignment
(a)
Verify frangible link hole on rocket motor case aligns with longer anchor block on launch
tube.
(b)
If frangible link hole and anchor block do not align, adjust rocket motor case.
1
Remove and retain nylon screws securing rocket base to rocket motor.
2
Remove rocket motor from launch tube.
3
Return rocket motor to workbench.
4
Reinstall steel screws securing rocket nozzle bulkhead to workbench. Torque to 3.0
±0.5 in-lb (33.9 ±5.6 Ncm).
5
Using large strap wrench at top of rocket motor case, slightly rotate rocket motor
case until frangible link hole aligns with longer anchor block.
CAUTION:
Do not over rotate Ortman key into slot.
6
Verify end of key remains visible in slot and is below flush with rocket motor case.
7
Repeat Inspection/Check - Rocket Motor Case Alignment.
4 May 2015
