Cirris Signature 1000HN, User Manual

Page: 31 / 86

1000HN User’s Guide / page 31
Why retrieve a cable?
Before the 1000HN can test cables, it has to be programmed with wirelist data for the
cables you intend to test. You can avoid having to re-learn a Sample Cable each time
you want to test, by storing the learned information in the analyzer’s memory (see
page 24 for instructions on how to do this). Once the information is stored, all you
have to do to set up for testing is to install the correct cable adapters on the analyzer,
then retrieve the cable data from memory in order to program the analyzer.
How to retrieve a cable To retrieve a learned cable’s data from memory and program the analyzer for testing,
do these things:
1. Install the connector adapters that mate with the cables you want to test (see
page 9 for instructions on how to do this).
2. Hold in the
Memory
button as you turn on the analyzer. Continue holding in the
Memory
button as you do the next step. The analyzer will prompt Ready To
Access Memory Locations .
3. Continue holding in the
Memory
button while you press
Display/Print
to step
through the Sample Cables stored in the analyzer’s memory. The first time you
press the switch the display prompts the signature of the cable in the “Last
Learned” memory location. When you press
Display/Print
again, the analyzer
Press and hold...
...as you turn the analyzer on
Section 6:
Retrieve a Cable
from Memory