Cirris Signature 1000HN, User Manual

Page: 10 / 86

Section 1: Work With the Hardware / How to install an expansion box
1000HN User’s Guide / page 10
3. Replace the cover plate, making sure the small alignment pins on its underside fit
into the corresponding holes on the scanner’s upper surface.
4. Lock the twistlock fasteners to hold the adapters firmly in place.
How to install an
expansion box
To increase the number of available test points, you can install an expansion box on
your 1000HN. You can set up your system to have as many as 256 test points.
To install an expansion box, follow these steps:
1. Unlock the twistlock fasteners on the top of the analyzer’s spacer and cover
plates, and on the top of the expansion box. Remove the cover plate and the
spacer plate.
2. Lift the scanner assemblies out of both the main unit and the expansion box.
(
Note
: Your expansion box may have a black plastic plate covering the opening
where you will be routing the scanner cable. Once the scanner has been removed,
push the plastic rivets out from the inside of the chassis, and remove the plastic
plate.)
• For photographic clarity in the top photo, we’ve removed the scanner
assembly from the main unit, and disconnected it. You see the connector
Each cover plate alignment pin...
...fits into a hole in the scanner’s
upper surface.
spacer plate
cover plate
Scanner assembly