8
PV-Monitor-M
Instruction Manual
3�- INSTALLATION OF THE DEVICE
3.1.- PREVIOUS RECOMMENDATIONS
In order to use the device safely, it is critical that individuals who handle it follow
the safety measures set out in the standards of the country where it is being used,
use the personal protective equipment necessary, and pay attention to the vari-
ous warnings indicated in this instruction manual.
The
PV-Monitor-M
device must be installed by authorised and qualified staff.
The power supply plug must be disconnected and measuring systems switched off before han-
dling, altering the connections or replacing the device. It is dangerous to handle the device
while it is powered.
Also, it is essential to keep the cables in perfect condition to avoid accidents, personal injury
and damage to installations.
The manufacturer of the device is not responsible for any damage resulting from failure by the
user or installer to observe the warnings and/or recommendations set out in this manual, nor for
damage resulting from the use of non-original products or accessories or those made by other
manufacturers.
If an anomaly or malfunction is detected in the device, do not use the device to take any meas-
urements.
Inspect the work area before taking any measurements. Do not take measurements in danger-
ous areas or where there is a risk of explosion.
Disconnect the device from the power supply (device and measuring system
power supply) before maintaining, repairing or handling the device's connections.
Please contact the after-sales service if you suspect that there is an operational
fault in the device.
