4�9�22� COST RATIO OF CONSUMED ENERGY
The cost per kWh of electricity of the three tariffs of the unit is
calculated on this screen.
Press key
for 3 seconds to edit the cost ratio selection. The
prog
icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly, increasing
the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to
modify the other values.
If you press the
key after changing the last digit, it will jump back to the first digit so you can
modify the previously programmed values again.
Press key
to browse the different tariffs.
To validate the data, press
for 3 seconds and the
prog
icon will disappear from the display.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
Maximum programming value:
1.9999.
Minimum programming value:
0.
Press key
to access the next programming step.
4�9�23� PROGRAMMING ALARM 1 (RELAY 1)
Note:
Configuration parameters not available for the
CVM-C10-FLEX
model
.
The variable code is selected on this screen, depending on
which will control alarm relay 1.
Press key
for 3 seconds to edit the code selection. The
prog
icon
will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to
modify the other values.
When you enter the code of a variable on the display, the symbols for that variable will be activated.
Set the value to 00 if you do not wish to program a variable.
58
CVM-C10
Instruction Manual
