4�9�- PROGRAMMING
From the programming menu you can:
Lock the status of the menu.
Define the transformation ratios.
Select the number of quadrants and type of installation.
Select the operation profile of the device.
Program the carbon emission ratio, kgCO
2,
.
Program the cost ratio.
Program the maximum demand parameters.
Delete the energy meters and the maximum and minimum values.
Modify the display's backlight.
Activate the harmonic display option.
Program alarms.
Program Modbus communications
The programming parameters are validated as follows:
When on reaching the last point on the programming menu (“
”) the key is pressed
At any point in the programming, by pressing the key
or
pressing for 3 seconds.
If the device is RESET before validation or no key is pressed for 30 seconds, the configuration will not
be stored in the memory.
To enter the programming menu press the
key for 3 seconds.
The home screen of the menu indicates whether the menu is locked or not:
UnLOC
When you enter the programming menu you can view and modify the
programming. Icon on the display indicates that the unit is not
locked.
LOC
When you enter the programming you can view the programming but
not modify it. Icon indicates the locking status.
Press key
to access the first programming step.
The following screen will be displayed if the programming menu is locked,
LOC
:
Enter the password in this screen to modify the programming
parameters.
Press key
for 3 seconds to edit the password. The
prog
icon will
be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly, increasing
the value of the flashing digit.
46
CVM-C10
Instruction Manual
