Introduction and Safety
6
216 Series Twin-Screw Pump -
Installation, Operation & Maintenance Manual
User safety
General safety rules
These safety rules apply:
•
Always keep the work area clean.
•
Pay attention to the risks presented by gas and vapors in the work area.
•
Avoid all electrical dangers. Pay attention to risks of electric shock or arc flash hazards.
•
Always bear in mind the risk of drowning, electrical accidents, and burn injuries.
•
If operating temperatures exceed 60
o
C (140
o
F), measures must be taken to avoid skin
contact
Safety equipment
Use safety equipment according with the company regulations. Use this safety equipment
within the work area:
•
Protective helmet
•
Safety goggles, preferably with side shields
•
Protective shoes
•
Protective gloves
•
Gas mask
•
Hearing protection
•
First-aid kit
•
Safety devices
Electrical connections
Electrical connections must be made by certified electricians in compliance with all
international, national, state, and local regulations. For more information about requirements,
see sections dealing specifically with electrical connections.
Precautions before work
Observe these safety precautions before you work with the product or are in connection with
the product:
•
Provide a suitable barrier around the work area, for example, a guard rail.
•
Make sure that all safety guards are in place and secure.
•
Make sure that you have a clear path of retreat.
•
Make sure that the product cannot roll or fall over and injure people or damage property.
•
Make sure that the lifting equipment is inspected and in good condition.
•
Use a lifting harness, a safety line, and a breathing device as required.
•
Allow all system and pump components to cool before you handle them.
•
Make sure that the product has been thoroughly cleaned.
•
Disconnect and lock out power before you service the pump.
•
Check the explosion risk before you weld or use electric hand tools.
