SERVICE MANUAL
–
Post eVolve Smart
7 - CHARGE POINT SLAVE DEVICES
CIRCONTROL, S.A.
–
Innovació, 3
–
08232
–
Viladecavalls (Barcelona)
Tel.: +34 937 362 940
–
Fax: +34 937 362 941
31
Web: www.circontrol.com
–
E-mail:
7.4
RFID READER (27)
The RFID reader is a device that can send and receive radio signals with RFID tags to
identify the end-user without physical contact between the Charge Point and the card.
There are two RF reader options
-
MIFARE: The default reader with a several ISO certificated.
-
LEGIC: Optional reader with a long range of ISO certifications.
7.4.1
MIFARE RFID READER
7.4.1.1
DEVICE CONFIGURATION PROCEDURE
STEP ACTION
1
RFID reader has a LED status indicator. Look at the LED status indicator
colour:
•
Green LED
: RFID configured and ready for
use. In this case, there is no additional
configuration required to operate with RFID
reader.
•
Orange LED
: RFID not configured. Follow
next steps to configure it.
2
Remember that the RFID reader shall be connected to port B on CCL1-MINI
master device.
3
Turn off the circuit breaker (Q3
, refers to “15
-Wiring diagram
s”
section) and
wait for a while.
4
Turn on the circuit breaker (Q03.1
, refers to “15
-Wiring diagram
s”
section)
and show the RFID card to the RFID reader.
RFID reader LED status indicator changes from orange to red.
5
Wait 5 minutes until the Charge Point ends their starting and the LED
beacon from plug A and plug B turned ON.
6
Look at the LED status indicator colour of the RFID card reader:
•
Green LED
: RFID configured and ready for use. In this case, process
is completed.
•
Red LED
: RFID not configured. Start again from the step number 3.
