SmartMonitor 2 PS Parents’ Guide
33
Step 7: Connect the Oximeter Patient Cable to the Monitor.
•
Insert the round end of the
oximeter patient cable into the top round connector found on the front of the
SmartMonitor 2 PS.
•
Line up the notch on the connector, and push until you feel the connector snap into place.
•
To remove the oximeter patient cable, grasp it at the base of the patient
input connector and gently pull
back. You should feel the connector body slide back and unlock the connector as you pull.
SpO
2
%
%
CAUTION:
Do not twist or turn the oximeter patient cable to remove it from the SmartMonitor 2 PS as this may damage the
oximeter patient cable and/or monitor.
WARNING:
The oximeter patient cable should not be placed over the top of the crib rail. It should be placed between the
vertical bars to avoid strangulation.
NOTE:
If the oximeter patient cable or probe is not connected when the monitor is turned on, the % (percent) display will show “OFF”
and SpO
2
alarms will not sound. If the sensor is connected while the monitor is on, the SpO
2
function will resume normal
operation from that point including SpO
2
alarms.