Setup & Configuration
HDE-VoIP Telephones
Page 16
Configure the Network Parameters
1. Click the
Networking
button to open the
Network Configuration
page (Figure 5).
Figure 5 - Network Configuration Page
2. On the
Network Configuration
page, enter values for the parameters indicated in Table 5.
3. After changing the parameters, click
Save
to store the settings before going to the other configuration pages. If no other
changes are required beyond this state, click
Reboot
to reset the device for other changes to take effect.
The new settings will not take effect if
Reboot
is clicked without saving first.
4. Connect the Telephone to the target network.
5. From a computer on the same network as the Telephone, open a browser with the new IP address of the Telephone.
Note: If changing from DHCP to STATIC Only: Once the reboot button has been selected, the webpage will show a
countdown timer. The timer will hit zero and will reset and continue with countdown. At this point the web page can be
shutdown and re-started. The web page will not automatically restart when switching from DHCP to STATIC.
