Setup & Configuration
HDE-VoIP Telephones
Page 10
7. RESET Switch
•
The RESET switch is used to get the IP address of the device or reset to factory defaults.
•
Press and release the RESET switch within a
5
second window and it will speak the IP address through the on
board speaker.
•
Press and hold the RESET switch for more than10 seconds until it indicates that it is restoring defaults and
rebooting the board.
8. Configure the Telephone Parameters
To configure the Telephone online use a standard web browser.
All Telephones are initially configured with the following default IP settings:
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
10.10.10.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
Table 1 - Factory Default Settings
a. Default if there is not a DHCP server present.
When configuring more than one Telephone attach the Telephones to the network and configure one at a time to avoid IP
address conflicts.
8.1. Telephone Web Page Navigation
Table 2 shows the navigation buttons that will be seen on every Telephone web page.
Web Page Item
Description
Link to the
Home
page.
Link to the Device Configuration page.
Link to the
Networking
page.
Link to the SIP Configuration page.
Link to the Audio Configuration page.
Link to the Event Configuration page.
Link to the Autoprovisioning Configuration page.
Link to the Update Firmware page.
Table 2 - Telephone Web Page Navigation
