CipherLab 9500PPC, Reference Manual

Page: 99 / 103

89
The tables below list reader settings as well as symbology settings for the 2D scan engine.
READER SETTINGS TABLE
2D DESCRIPTION DEFAULT
Decode Time-out Set the maximum time for decoding to continue during a
scan attempt.
1~9 (second) for ReaderCfg.exe – default to 3
5~99 (0.1 second) for programming – default to 99
3 sec.
Focus Mode Select the focus mode to control the working range:
Far Focus – optimized to read at its far position
Near Focus – optimized to read at its near position
Smart Focus – toggles the focus position after every
frame
Far Focus
Decode Illumination Decide whether to flash illumination on every barcode
capture to aid decoding.
Turn On (Internal LED )
Turn Off
On
AIM Pattern Decide whether to project the aim pattern during barcode
capture.
Turn On
Turn Off
On
Read Redundancy Level 1
Level 1 The following barcodes must be successfully read twice before being
decoded:
BARCODE TYPES CODE LENGTH
Codabar 8 characters of less
MSI 4 characters of less
Discrete 25 (=Industrial 25) 8 characters of less
Interleaved 25 8 characters of less
Level 2 All barcodes must be successfully read twice before being decoded.
Level 3 All barcodes except for the following barcodes must be successfully read
twice before being decoded.
Appendix IV
2D SCAN ENGINE