3
Introduction
INSTALLATION
1)
Screw the antenna to the cradle.
For initial configuration, skip steps 2 and 3.
2)
Remove the rubber cover at the back of the cradle.
3)
Insert your SIM card and replace the rubber cover.
4)
Seat the mobile computer in the cradle.
5)
Connect the power supply cord to a suitable power outlet, and the cradle’s LED will
become red (see LED 1). The cradle is ready for charging the mobile computer.
INSERTING SIM CARD
The SIM card orientation is as shown in the illustration above, with contacts facing down.
Do not insert your SIM card while resetting the cradle. Refer to Chapter 2
REMOVING SIM CARD
You will need pliers to take out your SIM card when it is not desired in use. Always
disconnect the power supply cord before removing the SIM card.
