CIMLINE P1, Owner'S/Operator'S Manual

Page: 49 / 80

49
Set Screw
Actuator Arm Pivot
Actuator Arm
Center Post
Arm Slide Socket Screw
General Maintenance of the Rock Gate, Continued …
Setting the limit switches
The rock gate moves quickly with a lot of force. Use
extreme caution and keep clear of the sliding gate
when preforming maintenance that requires the
actuator to be active.
1. Leave actuator plugged in and powered on
2. Remove guard covering the limit switches and clean out all dust and debris
3. Open the rock gate
a. Using a 3mm Allen wrench loosen the set screw on the actuator arm pivot
b. Using a screw driver rotate the center post until you hear / feel a click. This is the activation point
of the switch.
c. Rotate the actuator arm until its wheel is against the vertical plate on the sliding gate
d. Tighten the set screw on the actuator arm pivot
4. Close the rock gate and repeat steps 3a - 3d for that limit switch
5. Open and close the gate a couple of times to determine if more adjustment needed
a. Use a 3mm Allen wrench and loosen the arm slide socket screw on the actuator arm
b. Slide the arm inward for more travel and outward for less travel.
c. If the actuator is clicking, it has reached the end of its travel in that direction and you need to
extend that actuator arm.
6. Reinstall guard when finished
WARNING