Regulatory Compliance
7-3
3916 Service Delivery Switch
Hardware Installation and Start-up Manual
009-3226-001 Standard Revision E
Copyright
©
2013-2015 Ciena
®
Corporation
July 2015
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference
that may cause undesired operation.
Note:
Shielded cables are required to meet Class B. Some of the
supported optics do not meet the Class B requirements. See
Packet
Networking Transceivers Reference
(009-2011-602) for more information.
If this equipment does cause interference to radio or television reception, the
user is encouraged to try to correct the interference using the following
measures:
•
Reorient the receiving antenna.
•
Relocate the equipment with respect to the receiver.
•
Move the equipment away from the receiver.
•
Plug the equipment into a different outlet so that equipment and receiver
are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions.
Modifications to this product not authorized by Ciena could void the FCC
approval and negate your authority to operate the product.
VCCI - Japan
Note:
This is a Class B product based on the standard of the Voluntary
Control Council for Interference (VCCI) for information technology
equipment. If this equipment is used near a radio or television receiver in
a domestic environment, it may cause radio interference. Install and use
the equipment according to the instruction manual.
Summary of Contents for 170-3916-900
Page 87: ......
