21798-01-EN Rev. 04
Page 18
4.4 Receiver Module Installation
Determine a location for the receiver module where it can be mounted on a flat
surface that has a clear line-of-site to the SMART
hatch
sensor on the drum.
Avoid mounting where the wireless signal between the receiver module and the
sensor might be blocked by a metal obstruction, for example the water tank or
truck frame. Figure 13 shows an example mounting location.
The mounting location must also allow the 13 ft (4 m) receiver module cable to be
routed to the inside of the truck cab to the area where the telematics module will
be mounted.
Use self-tapping screws or equivalent to hold the receiver module securely
in place.
Figure 13: Receiver Module Mounted to Back of Truck Cab
CAUTION
The receiver module must provide a separation distance of at
least 25 cm [10”] from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter
except in accordance with FCC’s multi-transmitter policy.
Summary of Contents for SMART HATCH
