12 - OPTIONS AND ACCESSORIES
Options
Description
Advantages
Use
Corrosion protection,
traditional coils
Fins made of pre-treated aluminum (polyurethane and epoxy) Improved corrosion resistance, recommended for moderate
marine and urban environments
•
XtraFan
Fans with 100 Pa maximum available pressure. Each fan
equipped with a connection flange & sleeves allowing the
connection to the ducting system.
Ducted fan discharge, optimised temperature control, based
on the operating conditions and system characteristics
TD 100 to 300
Low noise level
Aesthetic and sound absorbing compressor enclosure
Noise level reduction by 1 to 2 dB(A)
•
Xtra Low Noise
Acoustic compressor enclosure and low-speed fans
Noise emission reduction at reduced fan speed
TD 100 to 300
Soft Starter
Electronic starter on each compressor
Reduced start-up current
•
Protection grilles
Metallic protection grilles
Coil protection against possible impact
•
Hydraulic module frost
protection
Electric heater on the hydraulic module
hydraulic module frost protection at low outside temperatures
down to -20°C
•
Master/slave operation
Unit equipped with supplementary water outlet temperature
sensor kit to be field-installed allowing master/slave operation
of two units connected in parallel
Optimised operation of two units connected in parrallele
operation with operating time equalisation
•
Lon gateway
Two-directional communication board complying with Lon Talk
protocol
Connects the unit by communication bus to a building
management system
•
Bacnet over IP
Two-directional high-speed communication using BACnet
protocol over Ethernet network (IP)
Easy and high-speed connection by ethernet line to a building
management system. Allows access to multiple unit
parameters
•
Compliance with Russian
regulations
EAC certification
Conformance with Russian regulations
•
Condenser screw
connection sleeves kit
Condenser inlet/outlet screw connection sleeves
Allows unit connection to a screw connector
•
M2M supervision
(accessory)
Monitoring solution which allows customers to track and
monitor their equipment remotely in real time
Real-time expert technical support to improve equipment
availability and reports at customer hand to monitor and
optimize operating equipment.
•
Anti-vibration mounts (kit) Elastomer antivibratils mounts to be place under the unit
(Material classified B2 fire class according to DIN 4102 ).
Isolate unit from the building, avoid transmission of vibration
and associate noise to the buiding. Must be associate with
flexible connection on water side
•
Condenser flexibles
connection (kit)
Flexibles connections on the condenser water side
Easy installation. Limit transmission of vibrations on the water
network
•
Set point adjustment by
4-20mA signal
Connections to allow a 4-20mA signal input
Easy energy managment, allow to adjust set point by a
4-20mA external signal
•
EN-33 AQUACIAT
CALÉO™
TD
