CIAT AQUACIAT CALEO CONNECT TOUCH, Instruction Manual

Page: 14 / 32

6.1 Main menu
Icon Displayed text * Description Name
General Parameters General parameters GENUNIT
Temperature Temperatures TEMP
Pressure Pressures PRESSURE
Setpoint Setpoints configuration SETPOINT
Inputs Inputs status INPUTS
Outputs Outputs status OUTPUTS
Pump Status Pump status PUMPSTAT
Runtime Run times RUNTIME
Modes Modes MODES
Domestic Hot Water Domestic Hot Water DHW_STAT
Configuration Configuration menu CONFIG1
* Displayed in French by default.
CAUTION: Since specific units may not include additional features, some tables may contain parameters that cannot
be configured for a given unit.
General Parameters Menu – GENUNIT
No. Name Status Default Unit Displayed text * Description
1 CTRL_TYP 0 to 2 - - Local=0 Net.=1 Remote=2 Operating mode:
0 = Local
1 = Network
2 = Remote
2 STATUS - - - Running Status Off, Running, Stopping, Delay, Trip out, Ready, Override, etc.
3 min_left 0 to 0 - min Minutes Left for Start Minutes before the unit start-up
4 SP_SEL 0 to 2 - - Setpoint Select Setpoint selection
5 0=Auto. 1=Spt1. 2=Spt2 0 = Auto (schedule control)
1 = Heating setpoint 1
2 = Heating setpoint 2
6 SP_OCC no / yes - - Setpoint Occupied? Setpoint occupancy status
7 CHIL_S_S disable / enable - - Net.: Cmd Start/Stop Unit start/stop via Network: When the unit is in Network mode, start/stop
command can be forced
8 CHIL_OCC no / yes - - Net.: Cmd Occupied Unit time schedule via Network: When the unit is in Network mode, the
forced value can be used instead of the real occupancy state
9 CAP_T 0 to 100 - % Percent Total Capacity Total unit capacity
10 DEM_LIM 0 to 100 - % Active Demand Limit Val Active demand limit value: When the unit is in Network mode, the minimum
value will be used compared to the status of the external limit switch
contact and the demand limit switch setpoint
11 SP - - °C Current Setpoint Current setpoint
12 CTRL_PNT 26.7 to 65.0 - °C Control Point Control point: Water temperature that the unit must produce
13 EMSTOP disable / enable - - Emergency Stop Emergency stop: Used to stop the unit regardless of its active operating type
14 ALM - - - Alarm Alarm state: Normal, Partial, Shutdown
*Displayed in French by default.
6 - CONNECT TOUCH CONTROL: DETAILED MENU STRUCTURE
AQUACIAT
CALEO
EN - 12