Chyron infinit! series, Operation Manual

Page: 459 / 978

iNFiNiT! Family Operation Manual
Revision D 11-5 Clock & Timer Displays
)XQFWLRQ,FRQV
The Clock Setup Utility window contains four function
icons:
Start (or Stop ), Reset , Backgrnd , and Quit .
6WDUW6WRS
This function toggles between
Start
and
Stop
, and either
starts or stops the timer. When a Timer is stopped, the
count is held at the time it was stopped. When the Timer
is restarted, counting resumes from that point. When a
Clock is stopped and restarted, however, the display is
updated to show the current time, + or - the offset, if any.
To toggle between Stop and Start from within the Clock
Setup menu:
• Press S .
Start
/
Stop
can also be toggled from the Message Com-
pose main menu:
• Press
CNTL 8
.
NOTE
Prior to starting a Clock or Timer, you
must exit the Format: or Mode: field.
Press
or move the cursor to exit
either field.
5HVHW7LPHUV2QO\
The Reset function is used to instruct the Timer to start
counting up from a specified time; or count down from a
specified time.
NOTE
Any time that is entered into the Set
Timer window (Figure 11-2) must be in
the same format that was set in the
Format: field (§11.2.1.2).