Chrysler 300 SRT 2019, Owner'S Manual

Page: 34 / 592

To program your key fobs, perform the following:
1. Cycle the vehicle’s ignition to the OFF posi-
tion.
2. Select a desired memory profile, 1 or 2.
NOTE:
If a memory profile has not already been set,
refer to
" Programming The Memory Feature " in
this section for instructions on how to set a
memory profile.
3. Once the profile has been recalled, push and
release the set (S) button on the memory
switch.
4. Within five seconds, push and release button
(1) or (2) accordingly. “Memory Profile Set”
(1 or 2) will display in the instrument cluster.
5. Push and release the lock button on the key
fob within 10 seconds.
NOTE:
Your key fobs can be unlinked to your memory
settings by pushing the set (S) button, and
within 10 seconds, followed by pushing the
unlock button on the key fob.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the
vehicle is not in PARK, a message will be
displayed in the instrument cluster display.
Driver One Memory Position Recall
•
To recall the memory settings for driver one
using the memory switch, push memory but-
ton (1) on the memory switch.
•
To recall the memory settings for driver one
using the key fob, push the unlock button on
the key fob linked to memory position 1.
Driver Two Memory Position Recall
•
To recall the memory setting for driver two
using the memory switch, push memory but-
ton (2) on the memory switch.
•
To recall the memory settings for driver two
using the key fob, push the unlock button on
the key fob linked to memory position 2.
A recall can be canceled by pushing any of the
memory buttons during a recall (S, 1, or 2), or by
pushing any of the seat adjustment switches.
When a recall is canceled, the driver’s seat and
steering column (if equipped) stop moving. A
delay of one second will occur before another
recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you cycle the vehicle’s ignition to the OFF
position.
•
When you cycle the vehicle’s ignition to the
OFF position, the driver seat will move about
2.4 inches (60 mm) rearward if the driver seat
position is greater than or equal to 2.7 inches
(67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you cycle the vehicle’s ignition to the ACC or
RUN position.
•
The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 of an inch (22.7 mm) forward of the rear
stop. At this position, there is no benefit to the
driver by moving the seat for Easy Exit or
Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later dis-
abled) through the programmable features in
the Uconnect system. Refer to “Uconnect Set-
tings” in “Multimedia”.
33