Chrysler 300 SRT 2019, Owner'S Manual

Page: 268 / 592

The Valet Mode Deactivation key pad will then
prompt you for your four digit PIN code. Enter
your PIN code, and press the “OK” button on the
touchscreen. Your vehicle will return to the de-
fault state whenever exiting Valet Mode.
NOTE:
If your four digit PIN is lost or forgotten, the
vehicle will exit Valet Mode after a battery dis-
connect for approximately five minutes. Recon-
nect the battery and cycle the ignition to the
RUN position; the vehicle will be in Auto Mode.
ECO MODE
Press the “Eco” button on the touchscreen on
the SRT Drive Modes main menu. Eco mode
modifies the vehicle’s engine and transmission
settings to provide improved fuel economy at a
trade-off with acceleration performance. In-
creased engine exhaust noise and/or vibration
may be noticed while Eco is active. This is
normal and a result of the increased amount of
operating conditions where the vehicle is al-
lowed to operate in four cylinder shutoff mode.
The Paddle Shifters will be disabled while in Eco
mode.
•
Changing the Drive Mode will deactivate Eco.
•
Eco will be disabled when another Drive
Mode is selected or “Eco” button is pressed.
STEERING WHEEL AUDIO
CONTROLS
The remote sound system controls are located
on the rear surface of the steering wheel at the
three and nine o’clock positions.
The right-hand control is a rocker-type switch
with a push-button in the center and controls the
volume and mode of the sound system. Pushing
the top of the rocker switch will increase the
volume, and pushing the bottom of the rocker
switch will decrease the volume.
Pushing the center button will make the radio
switch between the various modes available
(AM/FM, etc.).
The left-hand control is a rocker-type switch with
a push-button in the center. The function of the
left-hand control is different depending on which
mode you are in.
Valet Mode Deactivation PIN
Eco Mode
Steering Wheel Audio Controls (Back View Of
Steering Wheel)
267