Chrysler 300 SRT 2019, Owner'S Manual

Page: 24 / 592

WARNING!
•
Do not start or run an engine in a closed
garage or confined area. Exhaust gas con-
tains Carbon Monoxide (CO) which is odor-
less and colorless. Carbon Monoxide is
poisonous and can cause serious injury or
death when inhaled.
•
Keep key fobs away from children. Opera-
tion of the Remote Start System, windows,
door locks or other controls could cause
serious injury or death.
Remote Start Abort Message On The
Instrument Cluster Display — If
Equipped
The following messages will display in the in-
strument cluster display if the vehicle fails to
remote start or exits remote start prematurely:
•
Remote Start Aborted — Door Open
•
Remote Start Aborted — Hood Open
•
Remote Start Aborted — Fuel Low
•
Remote Start Aborted — Trunk Open
•
Remote Start Disabled — Start Vehicle To
Reset
•
Remote Start Aborted — Too Cold
•
Remote Start Aborted — Time Expired
The message will stay active until the ignition is
turned to the ON/RUN position.
To Enter Remote Start Mode
Push and release the remote start button on the
key fob twice within five seconds. The vehicle
doors will lock, the parking lights will flash, and
the horn will chirp twice (if programmed). Then,
the engine will start, and the vehicle will remain
in the Remote Start mode for a 15-minute cycle.
NOTE:
•
If an engine fault is present or fuel level is low,
the vehicle will start and then shut down in
10 seconds.
•
The park lamps will turn on and remain on
during Remote Start mode.
•
For security, power window and power sun-
roof operation (if equipped) are disabled
when the vehicle is in the Remote Start
mode.
•
The engine can be started two consecutive
times with the key fob. However, the ignition
must be cycled by pushing the START/STOP
button twice (or the ignition switch must be
cycled to the ON/RUN position) before you
can repeat the start sequence for a third
cycle.
To Exit Remote Start Mode Without
Driving The Vehicle
Push and release the remote start button one
time or allow the engine to run for the entire
15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the system
will disable with a one time push of the remote
start button for two seconds after receiving a
valid remote start request.
To Exit Remote Start Mode And
Drive The Vehicle
Before the end of 15-minute cycle, push and
release the unlock button on the key fob to
unlock the doors and disarm the vehicle security
alarm (if equipped). Then, prior to the end of the
15-minute cycle, push and release the START/
STOP button. If the START/STOP button is not
present, insert the key fob into the ignition
switch and turn the switch to the ON/RUN
position.
NOTE:
•
For vehicles not equipped with the Keyless
Enter-N-Go — Passive Entry feature, the
ignition switch must be in the ON/RUN posi-
tion in order to drive the vehicle.
•
For vehicles not equipped with the Keyless
Enter-N-Go — Passive Entry feature, the
message “Remote Start Active — Insert Key
and Turn To Run” will show in the instrument
cluster display until you insert the key.
•
For vehicles equipped with the Keyless
Enter-N-Go — Passive Entry feature, the
message “Remote Start Active — Push Start
Button” will show in the instrument cluster
display until you push the START button.
23