43
Remote Voltage
Distribution – IN
Unless an optional Z-Purge
pressurization system is
employed, Hazardous Area
panels (C1D2) require wiring
from a remote area (non-
hazardous). Each circuit will
need its own separate
voltage feed.
Non-Hazardous Area panels
are pre-wired.
Heater (Load) – OUT
Heat Trace or Other Resistive
Heater Loads are connected here.
Modules are labeled:
Zone A is the first circuit on each
module
Zone F is the last circuit on each
module
4 x 3 Pin & 2 x 2 Pin
Terminal Blocks
6
3
+
RTD 1 -
+
RTD 2 -
+
RTD 3 -
+
RTD 4 -
+
RTD 5 -
+
RTD 6 -
Sensor Input Module
DIN Rail Mounted
6 x 3 Pin & 1 x 2 Pin
Terminal Blocks
Alarm Contact
DIN Rail Mounted
4
1b
Power Module (6 Pack)
Side/Rear Panel Mounted
(2-Pack Not Shown)
1a
2
Control/Distribution
Module
DIN Rail Mounted
Summary of Contents for IntelliTrace ITAS
Page 4: ......