13
LAMP TEST
To verify operation of the display LED, push
t
and FUNC together. The instrument LEDs will
flash until the Lamp Test is turned off.
To turn off the Lamp Test, press
t
and FUNC
together.
No other pushbutton functions are operable during
the Lamp Test.
OPERATOR PARAMETERS
The following is a list of all the available control
parameters. Note that some parameters may not
be displayed according to the specific instrument
configuration.
Push the FUNC pushbutton, the 1601 will
alternately show the parameter and its value or the
status (ON or OFF) of the selected parameter.
Using
s
or
t
pushbutton it is possible to set the
desired value or the desired status.
By pushing the FUNC pushbutton, the instrument
saves the new value (or the new status) and goes
to the next parameter.
Param. DESCRIPTION
SP
Set point (in eng. units).
Range: from rL to rH.
n.rS
Manual reset of the alarms.
This parameter is available only when a
latching alarm has been programmed.
Set ON and push the FUNC pusbutton
to reset the alarms.
nnn
Security code for parameter protection.
This parameter is skipped if P11 = 0 or 1
ON = the instrument is in LOCK condition
OFF = the instrument is in UNLOCK condi-
tion
When it is desired to switch from LOCK
to UNLOCK condition, set a value equal
to P11 parameter.
When it is desired to switch from
UNLOCK to LOCK condition, set a value
different from P11 parameter.
AL
Alarm set point(in eng. units).
This parameter is present if an alarm is
configured.
1601-1-0C.p65
5/2/00, 1:45 PM
13