Christie Solaria One, Service Manual

Page: 55 / 88

Section 3: Parts and Module Replacement
Solaria One/Solaria One
+
Service Manual 3-27
020-101039-02 Rev. 1 (06-2013)
3.30.3 Remove the Projector Intelligence Faceplate Board
Note: When replacing the projector intelligence faceplate board, you must replace the anti-tamper label on the
side of the cardcage.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the card cage shroud.
4. Remove the 8 card cage faceplate screws.
5. Remove the card cage by the handles.
6. Remove the 4 screws from the RS232 PIBS1 and 3D Sync connectors.
7. Disconnect the communication cable between PIBS1 and PIBS1 faceplate board.
8. Remove the 4 hex screws securing the PIBS1 faceplate board to the faceplate.
9. Remove the PIBS1 faceplate board.
When reinstalling the PIBS1 and PIBS1 faceplate board you must perform Marriage so you can continue
to play encrypted content. See
Activate Marriage in the Solaria One or Solaria One
+
user manuals.
3.30.4 Remove the Integrated Cinema Processor
The ICP is located in the cardcage on the operator side of the projector. The ICP is the image processing
electronics for incoming video signals.
Note: When replacing the ICP, you must replace the anti-tamper label on the side of the cardcage.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the card cage shroud.
4. Remove the 8 card cage faceplate screws.
5. Pull the card cage faceplate out by the handles.
6. Remove the ICP from the cardcage by pushing the 2 white tabs.
When reinstalling the ICP, you must perform Marriage so you can continue to play encrypted content. See
Activate Marriage in the Solaria One or Solaria One
+
user manuals