Unpacking and handling the display
Secure Series II LCD Panels User Guide
7
020-001779-01 Rev. 1 (03-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
Follow these best practices when handling and mounting extreme narrow bezel panels:
Notice. If not avoided, the following could result in property damage.
•
When moving the panel, always use the handles. Do not carry the frame.
•
Do not twist, bend, or tilt the panel.
•
Do not apply excessive force to the sides of the bezel when mounting the panel or pushing into
its locked position.
•
Always handle the display panel from the sides or handles.
Follow the following guidelines before removing the panel from the packaging
•
To verify normal operation before handling, power on the panel in the packaging.
•
Always use the handles to pick up and carry the panel.
•
Leave the panel in the box until the mount is on the wall and you are ready to install the panel.
•
To avoid putting undue stress on the panel when mounted, make sure the mount is square, flat, and
level.
•
Do not rest panels on top of a lower panel.
•
When inserting the panel into the wall, pay close attention to adjacent panels.
•
Make sure there is a minimum of 0.5 mm between mounted panels to allow for thermal expansion.
Learn how to clean the display panel.
1.
After disconnecting the power cable, wipe contaminated parts and each part of the product screen
lightly with a dry and soft cloth.
•
Do not use a liquid, spray cleaners, or any abrasive cleaners to clean the LCD panel.
•
Washing with various cleaning agents, brighteners, abrasives, waxes, benzene, alcohol,
solvent, surface active agent, may damage the surface of the product.
For installation, setup, and user information, see the product documentation available on the Christie website.
Read all instructions before using or servicing this product.
