3. Loosen the vertical lock screw (A).
4. Extend the lens focus (B) completely.
5. Adjust the Focus knob to retract the lens.
Watch the image at the top edge of the screen until it comes into focus. If the entire screen is
in focus, proceed to step 8.
6. Continue retracting the lens.
a) If the bottom edge of the image comes into focus before the lens is completely
retracted, adjust the vertical boresight bolt (C) to direct or aim the lens mount up
towards the top of the screen to balance out the top/bottom edges.
b) If the top edge of the image is not in focus, adjust the vertical boresight bolt (C) to
direct or aim the lens mount toward the bottom of the screen
7. When both sides appear equally blurry, adjust the horizontal and/or vertical offset to re-
center the image on the screen.
8. Repeat Steps 2 to 7 until the top and bottom of the screen are both well-focused.
9. Re-focus the center of the image. The goal is for good focus at the center and on all sides.
10. Tighten the lock screw (A) and the lens mount stabilization screw (D) to maintain the
adjustments.
11. Check the boresight again.
12. Perform a lens calibration, tap Menu > Configuration > Calibrate Lens Motors.
Adjusting the fold mirror
The fold mirror is used to bend the optical path.
If a corner or edge of an image is missing, the fold mirror might be misaligned with the optical system
and needs to be re-adjusted.
Warning! Failure to comply with the following could result in death or serious injury.
•
UV EXPOSURE! Protective UV safety glasses with side shields and Christie approved protective
safety clothing must be worn when performing optical adjustments or servicing the product.
1. Locate the two adjustment screws near the fold mirror, underneath the front of the projector.
Service setups
Roadie 4K35 and 4K45 Service Manual
24
020-101694-03 Rev. 1 (01-2016)
Copyright
©
2016 Christie Digital Systems USA Inc. All rights reserved.