Setting the temperature units
Change the units used when reporting the temperature.
1. Log in to the Remote Power Supply Rack Shelf web interface (on page 9).
2. Select Controller > Temperature Units.
3. Select whether the display units are Celsius or Fahrenheit.
4. Click Save.
Resetting the breakers
When too many panels are connected or too much power is sent through the Remote Power Supply
Rack Shelf, the breakers may interrupt the current flow. Reset the breakers to resume operation.
If the breakers disconnect the current, the On button is released for the affected Output.
1. Reduce the number of panels connected to the input or the amount of power going through the
input.
2. Push the On button back into place.
The current is reconnected and the output is powered.
Installing and configuring the Remote Power Supply Rack Shelf
Remote Power Supply Rack Shelf Installation and Setup Guide
11
020-102093-03 Rev. 1 (04-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
