Operation
Mirage WQ-L User Manual
51
020-101372-01 Rev. 1 (04-2014)
Ethernet Settings
To access the Ethernet Settings window select Configuration > Communication > Ethernet
Settings from the Main menu.
IP Address: Enter a valid and unique IP address for use on the network to which the projector is
currently connected. This address will overwrite any previous IP address such as the projector
factory-defined default. It takes approximately ten seconds for the projector to respond to its new
address.
TCP Port: On some Ethernet networks, firewall restrictions may require that the port number of
the projector be changed from its default of 3002. If so, enter a new valid port number here. It is
highly recommended not to use a port number below 1000, as these ports are typically reserved for
and used by common IP applications.
Subnet Mask: Subnet Mask determines the subnet mask for the IP address and must be set
manually.
Gateway: This is the IP address of the gateway used to reach any non-local IP addresses; it must
be set manually.
Host Name: Set the hostname for the device.
Domain Name: Set the domain for the device.
MAC Address: Displays the MAC address of the projector (read-only).
Broadcast Keys
Use Broadcast Keys to relay all key presses received by the projector to all other projectors on the
network.
Front IR Enabled
Check this option to enable the front IR sensor.
Wired Keypad Enabled
Check this option to use the wired keypad.
Display Error Messages
Choose how you want to be notified of errors detected in either the incoming signal or projector.
Select Serial Ports to receive messages using RS232 or RS422 serial communication only. To hide
error message displays, such as during shows and presentations, select Off.
Language
Choose the available language to use in the projector menus. The change will take effect
immediately.
Diagnostics and Calibration
To access this menu select Configuration > Diagnostics and Calibration.
i
Recommended for Network Administrators only.
