Installation
Mirage WQ-L User Manual
16
020-101372-01 Rev. 1 (04-2014)
Install the Lens
1. Remove the lens plug from the lens opening.
2. Remove the rear lens cap from the lens.
3. Rotate the lens clamp to the open position.
4. Remove and retain the two security screws from the lens mount.
5. Align the lens interface plate with the lens mount. Fully insert the assembly straight into the
lens mount opening without turning.
6. Rotate the lens clamp to the closed position before fastening the security screws.
Risk Group 2: Possible hazardous optical radiation emitted from this product.
Do not stare at operating lamp. May be harmful to the eyes. Failure to comply
could result in minor or moderate injury.
Failure to comply with the following may result in equipment damage:
• Do not insert the lens at an angle.
• Always replace the lens plug when transporting to protect the optical components.
• Always place the lens cap onto the lens when transporting to avoid scratching the lens.
• Never operate the projector without a lens.
• A small amount of dust or dirt on the lens has minimal effect on image quality. To avoid the
risk of scratching the lens, clean only if absolutely necessary. See
For some installations security screws are required on the lens.
D o not stare at operating lam p.
M ay be harm ful to the eyes.
Possible hazardous optical radiation
em itted from this product.
C AU TIO N /
R isk G roup 2/
è
q³I§
2
è
q³I§
2
,§ÁïýÑúqi„I
÷ÿ ÝÆå\-„oˇ
ïý$³¨„<[
÷ÿ ÝÆå\-„oˇ
ïý$³¨„<[
Lens clamp
(closed position)
Security screw
Security screw
